 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| Internationally Approved Rockers/Paddles Series P Distinctive Characteristics International certifications from UL, CSA, VDE, SEMKO, and SEV. Contacts of special silver alloy resist arcing and guarantee stable electrical contact and long life. Stainless steel frame resists corrosion and increases environmental safety. High insulating barriers increase isolation of circuits in double pole devices and provide added protection to contact points. Case/base of heat resistant resin meets UL94V-0 flammability standard. Prominent external insulating barriers increase insulation resistance and dielectric strength. Clinching of the frame to the case well above the base and terminals provides 4,000V dielectric strength. Epoxy sealed terminals prevent entry of flux, solvents, and other contaminants. Actual Size NKK Switches * email: sales@nkkswitches.com * Phone (480) 991-0942 * Fax (480) 998-1435 * www.nkkswitches.com 03-07 Internationally Approved Rockers/Paddles Series P General Specifications Electrical Capacity Resistive Load: Motor Load: Lamp Load: 10A @ 125V AC or 6A @ 250V AC 400W @ 125V AC 2A @ 125V AC for On-Off-On circuit & 3A @ 125V AC for other circuits Other Ratings Contact Resistance: Insulation Resistance: Dielectric Strength: Mechanical Life: Electrical Life: Angle of Throw: 10 milliohms maximum 1,000 megohms minimum @ 500V DC 2,000V AC minimum between contacts for 1 minute minimum; 4,000V AC minimum between contacts & case for 1 minute minimum 50,000 operations minimum 25,000 operations minimum 25 Materials & Finishes Frame: Case/Base: Movable Contacts: Stationary Contacts: Terminals: Stainless steel Diallyl phthalate resin (UL94V-0) Silver alloy with silver plating Pure silver with silver plating Copper with silver plating Environmental Data Operating Temp Range: Humidity: Vibration: Shock: -10C through +85C (+14F through +185F) 90 ~ 95% humidity for 96 hours @ 40C (104F) 10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 1 minute; 3 right angled directions for 2 hours 50G (490m/s2) acceleration (tested in 6 right angled directions, with 5 shocks in each direction) Installation Soldering Time & Temp: Wave Soldering (Straight PC): See Profile A in Supplement section. Manual Soldering: See Profile A in Supplement section. Standards & Certifications Flammability Standards: UL Recognized: R UL94V-0 rated case/base All models recognized at 10A @ 125V AC & 6A @ 250V AC; UL File No. WOYR2.E44145. All models recognized at 10A @ 125V AC & 6A @ 250V AC; C-UL File No. WOYR8.E44145. Single pole models certified at 10A @ 125V AC & 6A @ 250V AC; CSA File No. 023535-0-000. All models approved at 10A @ 125V AC & 6A @ 250V AC; VDE License No. 119174. Marking on switch is standard. P2011Y, P2012Y, P2013Y, P2021Y, P2022Y models approved at 10A @ 125V AC & 6A @ 125/250V AC; Reference No. 9915205/01-02. Marking on switch is standard. All models with quick connect terminals approved at 10A @ 125V AC & 6A @ 250V AC; (P2013 only for micro-switch off); Authorization No. 02.0466. Marking on switch is standard. C-UL Recognized: CSA Certified: V DE VDE Approved: SEMKO Approved: SEV Approved: NKK Switches * email: sales@nkkswitches.com * Phone (480) 991-0942 * Fax (480) 998-1435 * www.nkkswitches.com 03-07 Internationally Approved Rockers/Paddles TYPICAL SWITCH ORDERING EXAMPLE Series P C P20 POLES & CIRCUITS 11 12 13 21 22 23 SPST SPDT SPDT DPST DPDT DPDT ON ON ON ON ON ON NONE NONE OFF NONE NONE OFF 22 OFF ON ON OFF ON ON Y TERMINALS No Code P Z Solder Lug Straight PC .187" (4.75mm) Quick Connect J PADDLE/ROCKER FRAMES N Y Frame for Small Caps Frame for Large Caps D E J H ROCKER/PADDLE CAPS For N Frame .365" (9.27mm) Wide Rocker .365" (9.27mm) Wide Paddle For Y Frame .595" (15.11mm) Wide Rocker .595" (15.11mm) Wide Paddle CAP COLORS A B C E F G H Black White Red Yellow Green Blue Gray IMPORTANT: VDE, SEMKO & SEV are marked on approved models. Switches are supplied without UL, C-UL & CSA marking unless specified. Specific models & ratings noted on General Specifications page. DESCRIPTION FOR TYPICAL ORDERING EXAMPLE P2022Y-JC .595" (15.11mm) Wide Red Rocker DPDT ON-NONE-ON Circuit Frame for Large Caps Solder Lug Terminals NKK Switches * email: sales@nkkswitches.com * Phone (480) 991-0942 * Fax (480) 998-1435 * www.nkkswitches.com 03-07 Internationally Approved Rockers/Paddles POLES & CIRCUITS Rocker Position Down Pole SP Model P2011 P2012 P2013 P2021 P2022 P2023 ON ON ON ON ON ON NONE NONE OFF NONE NONE OFF OFF ON ON OFF ON ON 1-1b OPEN OPEN SPST Center Up Connected Terminals Down Center Up Note: Series P Throw & Schematics Terminal numbers are on the switch. 1 (COM) 1b 1 (COM) SP 1-1b OPEN 1-1a SPDT 1 1a (COM) 1b 1 (COM) 1b 2a 2 1b DP 1-1b 2-2b OPEN OPEN DPST 2b 2 2b DP 1-1b 2-2b OPEN 1-1a 2-2a DPDT 1a ROCKER/PADDLE FRAMES N Frame for Small Actuator Using AT4148 & AT4149 (3.2) Dia Typ .126 Y Frame for Large Actuator Using AT4148 & AT4149 (3.2) Dia Typ .126 (6.0) .236 (34.9) 1.374 (41.3) 1.626 (17.8) .701 (34.9) 1.374 (34.9) 1.374 (41.3) 1.626 (28.5) 1.122 (34.9) 1.374 (12.8) .504 (13.5) .531 (10.1) .398 (3.5) Dia Typ .138 (12.8) .504 (16.0) .630 (3.5) Dia Typ .138 Maximum Panel Thickness: .126" (3.2mm) Maximum Panel Thickness: .126" (3.2mm) TERMINALS No Code Solder Lug Epoxy Seal (2.6) .102 (2.0) (4.5) .079 .177 (1.25) .049 Thk = (1.0) .039 Z .187" (4.75mm) Quick Connect (6.35) .250 (1.3) Dia .051 (9.0) .354 (4.75) .187 Thk = (0.8) .031 Epoxy Seal P Straight PC (7.6) .299 (1.17) .046 Thk = (1.0) .039 1b 1b 2b 1b 2b 1b (4.8) .189 SPST 1 (7.62) Typ .300 (1.8) Dia Typ .071 SPDT 1 (7.62) Typ .300 DPST 2 1 (7.62) Typ .300 (1.8) Dia Typ .071 DPDT 2 1 (7.62) Typ .300 1a (1.8) Dia Typ .071 (10.16) .400 2a 1a (10.16) .400 (1.8) Dia Typ .071 NKK Switches * email: sales@nkkswitches.com * Phone (480) 991-0942 * Fax (480) 998-1435 * www.nkkswitches.com 03-07 Internationally Approved Rockers/Paddles ROCKER/PADDLE CAPS For N Frame AT4148 .365" (9.27mm) Wide Rocker (9.27) .365 (16.87) .664 (13.49) .531 (7.9) (6.15) .311 .242 (8.8) .346 (3.5) .138 Series P D E AT4149 .365" (9.27mm) Wide Paddle (9.27) .365 (18.8) .740 (2.13) .084 (3.96) .156 (8.43) R .332 For Y Frame (16.8) .661 (3.5) .138 J AT4156 .595" (15.11mm) Wide Rocker H AT4157 .595" (15.11mm) Wide Paddle (14.33) .564 (2.36) .093 (4.75) .187 (13.5) R .531 (7.3) .287 (15.11) .595 (26.8) 1.055 (3.5) .138 (15.11) .595 (26.78) 1.054 (23.01) .906 (6.6) (10.11) .260 .398 (11.0) .433 (3.5) .138 (29.82) 1.174 Cap Colors Available: A Black B White C Red E Yellow F Green G Blue H Gray Material: Polyamide Finish: Matte TYPICAL SWITCH DIMENSIONS N Frame (12.8) .504 (12.3) .484 (0.6) .024 (1.25) x (2.0) Typ .049 x .079 (1.0) Typ .039 (34.9) 1.374 (41.3) 1.626 (0.8) .031 25 (7.62) .300 1b (3.2) Dia Typ .126 1 (20.5) .807 1a (9.27) .365 (13.5) .531 (9.65) .380 (3.5) .138 (22.0) .866 (0.5) .020 (5.0) .197 (11.0) .433 (2.6) .102 P2012N-DC P2011 & P2021 models do not have terminals 1a & 2a. (3.2) Dia Typ .126 (14.5) .571 (0.6) .024 (1.25) x (2.0) Typ .049 x .079 (1.0) Typ .039 (34.9) 1.374 (41.3) 1.626 (0.8) .031 25 (7.62) .300 (0.5) .020 (12.8) .504 (15.11) .595 (3.5) .138 (21.7) .854 (5.0) .197 (10.16) .400 (20.0) .787 2b 1b Y Frame (2.6) Typ .102 2 1 (20.5) .807 2a 1a (10.1) .398 P2022Y-JC P2011 & P2021 models do not have terminals 1a & 2a. 03-07 NKK Switches * email: sales@nkkswitches.com * Phone (480) 991-0942 * Fax (480) 998-1435 * www.nkkswitches.com |
Price & Availability of P2011Y-HA
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |